Hopefully, Bambu Lab will also provide a similar print surface in the future, as I love the textured finish on my prints. This is a bit smaller than the original surface but it worked pretty well after aligning it to the back-right side of the bed. COVID 19 testing Laboratory - Lifenity (ICMR approved and NABL accredited lab). I don’t have this surface, so I haven’t tried it, but I did quite a few prints on a Ultistick sheet made for Prusa MK3S. Also, know about travel guidelines, COVID-19 related queries, Air Suvidha. The calibration values will remain in the printer’s memory, so when you start the print on the textured plate, select just the bed leveling, and disable flow rate calibration. It’s recommended to use the stock print surface to do the flow rate calibration, then switch to the textured plate. If you decide to get one of these print surfaces, it’s important to note that the LIDAR can have a bad time correctly measuring and calibrating the flow rate of the printing surface. The one I linked previously is a bit more expensive, but it gives you the choice of having one side smooth, and the other side textured. They offer it in Gold but a black variant is also available to purchase.
0 kommentar(er)
